cNw 3 Phase Alternator System
$498.00
In stock
SKU
Manufacturer: cNw / Wassell
0703-03
- High quality stator. Great performance to keep your battery fully charged even when under load
- 3 phase
- 180 Watt @ 12.5 volts
- 85 % full output at 2400 RPM’s
- Exceeds the required output needed at low RPM’s
- 9 pole welded rotor
- Rotor is machined at cNw to provide better clearance and reduce/eliminate the risk of contact and ultimatley failure.
- Solid state Mosfet regulator by Tri Spark
- Regulator wires are extended to reach the primary area to hook up with the stator
- Marine grade connectors for stator / regulator hook up
- A cNw regulator bracket for an easy placement and install. Powder coated Black. With stainless mounting hardware
- Perfect match with our Single coil and Tri Spark ignition for an extremely simplified electrical system
- Works with 750. 850 and MkIII Commandos
Note: Two 1/4 holes need to be drilled in the flat frame plate behind the battery box in order to mount the cNw voltage regulator bracket
- High quality stator. Great performance to keep your battery fully charged even when under load
- 3 phase
- 180 Watt @ 12.5 volts
- 85 % full output at 2400 RPM’s
- Exceeds the required output needed at low RPM’s
- 9 pole welded rotor
- Rotor is machined at cNw to provide better clearance and reduce/eliminate the risk of contact and ultimatley failure.
- Solid state Mosfet regulator by Tri Spark
- Regulator wires are extended to reach the primary area to hook up with the stator
- Marine grade connectors for stator / regulator hook up
- A cNw regulator bracket for an easy placement and install. Powder coated Black. With stainless mounting hardware
- Perfect match with our Single coil and Tri Spark ignition for an extremely simplified electrical system
- Works with 750. 850 and MkIII Commandos
Note: Two 1/4 holes need to be drilled in the flat frame plate behind the battery box in order to mount the cNw voltage regulator bracket
A great high output 3 phase system that not only gives you a higher charging rate, especially at lower RPM’s, but also greatly simplifies your system by eliminating all of the questionable components from the original set up. A must if you run lights continuously