cNw Stainless Steel Mufflers
- All stainless steel including the internal packing material
- 20 gauge stainless makes for a rich sound and rigid construction. The throat where is slides over the header pipe is 16 gauge
- Designed to be used with 1 3/8 header pipes
- All welds are ground down for a seamless look
- Show polished finish. Easily re-polished to remove scuff marks etc
- Clean 2 post mount to fit a std muffler bracket
- Rich, deep sound but still powerful enough to make your Commando sound better than ever
- Includes a high quality, stainless steel clamp. This clamp is wide to ensure a secure mount to the header pipe
- The seam is located on the inside, so there is not a left and right specific muffler
- Made in the USA
Note: The cNw logo is CNC machined into the metal on top but on one side only. This means you can install them to show the cNw brand or switch them around from left to right, if you prefer not to have the logo show
- All stainless steel including the internal packing material
- 20 gauge stainless makes for a rich sound and rigid construction. The throat where is slides over the header pipe is 16 gauge
- Designed to be used with 1 3/8 header pipes
- All welds are ground down for a seamless look
- Show polished finish. Easily re-polished to remove scuff marks etc
- Clean 2 post mount to fit a std muffler bracket
- Rich, deep sound but still powerful enough to make your Commando sound better than ever
- Includes a high quality, stainless steel clamp. This clamp is wide to ensure a secure mount to the header pipe
- The seam is located on the inside, so there is not a left and right specific muffler
- Made in the USA
Note: The cNw logo is CNC machined into the metal on top but on one side only. This means you can install them to show the cNw brand or switch them around from left to right, if you prefer not to have the logo show
Due to a void in the market for a high quality, stainless steel muffler we decided to start manufacturing our own. We made contact with one of the premier custom exhaust manufacturers in the country, Cone Engineering, and started looking at what it would take to make a muffler than not only looked right but also had the sound where were after. The design is the classic reverse cone style and it’s finished in a high luster polish. The tooling and jigs for this was made from scratch to ensure a round, perfect taper without any variance from one batch to the next. The packing is dense which offer a nice deep sound yet its loud enough to get your attention without being obnoxious. The polished finish is stunning and the fact that’s its stainless steel, will allow you to re-polish them to remove scuff marks, imprints or anything else that has compromised the finish over time
